ZAP! Embossing heat tool – heat gun for removing resin bubbles

The ZAP heat tool is perfect for applying heat to resin to pop surface bubbles. The low velocity, hot air flow, makes getting rid of those pesky bubbles a breeze! How do you use this heat gun to remove bubbles from resin? Quickly move the heat gun no closer than 1 1/2 inches away from your project to avoid damaging a mold or delicate bezel setting. Repeat as necessary to remove bubbles from the resin surface. Attach the stand rest on the front to allow you to set it on a surface without causing heat damage. Note: Heat gun end will get very hot.

Source by resinobsession

About The Author

Leave a Comment

Your email address will not be published. Required fields are marked *